Installation guide

CAUTION
Static electricity can damage the chassis and other electronic devices. To avoid damage,
keep static-sensitive devices in their static-protective packages until you are ready to install
them.
Cable management comb removal and replacement
You can can continue to operate the device during the replacement of the cable management comb.
Time and items required
The replacement procedure for the cable management comb takes less than 5 minutes. A #1 Phillips
screwdriver is required.
Removing a cable management comb
Complete the following steps to remove the cable management comb. Refer to the illustration provided
with the procedure.
1. Remove the cables from the cable management comb and rearrange the cables around the comb.
2. Unscrew and save the four (4) screws holding the cable management comb to the chassis. Retain
the screws. Support the cable management comb to prevent it from falling.
3. Remove the cable management comb.
Cable management comb removal and replacement
70 Brocade VDX 8770-8 Hardware Installation Guide
53-1002564-07