Specifications

spinSilk
781Fabric OS Version 3.1.x/4.1.x Reference Guide
Example
To run spinsilk on a switch:
For lb_Mode == 2,3 the following speed modes are
available to test fifo underrun.
3,5: set all even ports' speed for 2 Gbit/sec, set all odd
ports' speed for 1 Gbit/sec.
4,6: set all even ports' speed for 1 Gbit/sec, set all odd
ports' speed for 2 Gbit/sec.
-verbose mode
(V4.1.x only)
Specify a non-zero value, to display more detailed
information during the test. This mode should be used for
debugging purpose. This operand is optional.
-ports itemlist
(V4.1.x only)
Specify a list of user ports to test. By default all of the user
ports in the current switch are tested. This option may be
used to restrict testing to the specified ports.
switch:admin> spinsilk 2
Running Spin Silk .............
One moment please ...
switchName: switch
switchType: 2.2
switchState: Testing
switchRole: Disabled
switchDomain: 1 (unconfirmed)
switchId: fffc01
switchWwn: 10:00:00:60:69:00:73:71
port 0: cu Testing Loopback->15
port 1: sw Testing Loopback->11
port 2: sw Testing Loopback->6
port 3: lw Testing Loopback->4
.
.
.
Transmitting ... done.
Spinning ...
port 0 Rx/Tx 1 of 1 million frames.
port 1 Rx/Tx 1 of 1 million frames.
port 2 Rx/Tx 1 of 1 million frames.
port 3 Rx/Tx 1 of 1 million frames.
.
.
.