Specifications

sectemppasswdset
739Fabric OS Version 3.1.x/4.1.x Reference Guide
Set a temporary password on a remote switch.
Synopsis
sectemppasswdset domain, login_name
Availability
Admin
Release
V3.1.x and V4.1.x
Description
Use this command to set a unique temporary password for a given account on a
specific switch in the fabric. Use the sectemppasswdreset command to
remove the temporary password or reboot the switch.
You can change any password on any switch. In order to the change the password
of an account which has higher level than that of the current user logged into the
primary FCS switch, you must enter the password of the same level account on the
primary FCS switch.
The password setup on the target is not persistent and will be reset to the secure
fabric-wide setting when this target switch is rebooted or when
sectemppasswdreset is run on primary FCS switch.
Each switch has four accounts; Root, Factory, Admin and User. Root and Factory
accounts are disabled for non-FCS switches. This command can enable the Root
or Factory account on a non-FCS switch when you specify a password for those
accounts.
The password should be at least 8 characters long and no more than 40 characters.
Note: When security is enabled, this command can only be issued from the Primary
FCS switch. See “Security Commands” on page 941.
sectemppasswdset