Specifications

Fabric OS Commands
638 Fabric OS Version 3.1.x/4.1.x Reference Guide
Operands
This command has the following operands:
Example
To display the port properties for slot 1 port 2:
See Also
chippropshow
ptregshow
slotnumber Specify the slot number for a StorageWorks Core
switch. For all other switches this operand is not
required. The slot number must be followed by a slash
( / ) and the port number, so that each port is
represented by both slot number (1 through 4, or 7
through 10), and port number (0 through 15).
The StorageWorks Core switch has a total of 1–10
slots. Slot number 5 and 6 are control processor cards,
and slot 1 through 4, and 7 through 10, are port
cards. On each port card, there are 16 ports counted
from the bottom, 0 to 15.
portnumber Specify a port number. Valid values for port number
vary depending on the switch type. This operand is
required.
[slot] -all Specify which slot to operate on. The entire ports in the
slot will be displayed. If slot is not specified, the
current slot will be assumed. This operand is optional.
switch:admin> ptpropshow 1/2
Port Property for slot: 1, port: 2
P2: [be,3,2],SP,CAP:[1,1,1,(1,1,0)],WWN: 00:00:00:00:00:00:00:00
switch:admin>