Specifications

Fabric OS Commands
580 Fabric OS Version 3.1.x/4.1.x Reference Guide
There is further information about the login after the above columns. This can
include the DID (Destination Identifier) that the port is logged on to.
Operands
This command has the following operands:
Example
The following example shows an N_Port with one FLOGI and two PLOGIs:
See Also
portshow
fcpprobeshow
slotnumber
(V4.1.x only)
Specify the slot number for a StorageWorks Core
switch. For all other switches this operand is not
required. The slot number must be followed by a slash
( / ) and the port number, so that each port is
represented by both slot number (1 through 4, or 7
through 10), and port number (0 through 15).
The StorageWorks Core switch has a total of 1–10 slots.
Slot number 5 and 6 are control processor cards, and
slot 1 through 4, and 7 through 10, are port cards. On
each port card, there are 16 ports counted from the
bottom, 0 to 15.
portnumber Specify a port number. Valid values for port number
vary depending on the switch type. This operand is
optional.
switch:admin> portloginshow 2
Type PID World Wide Name credit df_sz cos
=====================================================
fe 201700 21:00:00:e0:8b:05:a3:c9 3 2048 8 scr=1
ff 201700 21:00:00:e0:8b:05:a3:c9 0 0 8 d_id=FFFC20
ff 201700 21:00:00:e0:8b:05:a3:c9 0 0 8 d_id=FFFFFC