Specifications

portLEDTest
569Fabric OS Version 3.1.x/4.1.x Reference Guide
Exercise the user port LEDs.
Synopsis
portLEDTest [-npass count][-ports itemlist]
Availability
Admin
Release
V4.1.x
Description
Use this command to exercise the user port LEDs in the current switch ON/OFF
by setting the ATTN LEDs to green for the ON condition and black for the OFF
condition. The SPEED LEDs are initially set to black before the command
execution. The SPEED LEDs are set to green once the command is executing.
You must disable the current switch (using the switchdisable command)
before running this command. After the command had completed, the ATTN
LEDs flash amber indicating the command has finished and exited. You can
enable the current switch (using the switchenable command) to set the
ATTN LEDs back to black.
Options
This command has the following operands:
portLEDTest
-npass count Specify the number of times to perform this test. The
default value is 10.
-ports itemlist Specify a list of user ports to run the test. If omitted, all
the active ports in the switch are assumed. For more
information refer to the itemlist command.