Specifications

Fabric OS Commands
510 Fabric OS Version 3.1.x/4.1.x Reference Guide
Set overall mask for end-to-end (EE) monitors.
Synopsis: V3.1.x
perfSetPortEEMask portnumber, “TxSIDMsk”,”TxDIDMsk”,
”RxSIDMsk”,”RxDIDMsk”
Synopsis: V4.1.x
perfSetPortEEMask [slotnumber/]portnumber, “TxSIDMsk”,
”TxDIDMsk”,”RxSIDMsk”,”RxDIDMsk”
Availability
Admin
Release
V3.1.x and V4.1.x
Description
Use this command to set the mask for the EE monitors of a port. This command
enables a user to selectively choose the kind of Fibre Channel frames in which the
number of words are to be counted.
EE monitors are defined by the perfAddEEMonitor command using SID
and DID pairs. This command can be used to match the entire SID or DID to
trigger the monitor to count Fibre Channel words. It can also be used to match one
or two of the three fields (Domain ID, Area ID and AL_PA ID) in SID and DID
pair to trigger the monitor.
The EE mask is used to set up a flag on each field to control whether the field is
used to trigger the monitor.
When a flag bit is set (ff), the corresponding field will be used to qualify the
triggering of the monitor. If a flag is reset (00), then that field is ignored and its
value will not be used to qualify monitor-triggering.
There is only one EE mask per port. The mask is applied to all eight EE monitors
available on a port. The default EE mask value upon power-on is all eight EE
monitors set. When you reset mask, the counters are also reset to 0.
perfSetPortEEMask