Specifications

Fabric OS Commands
386 Fabric OS Version 3.1.x/4.1.x Reference Guide
Information: V4.1.x
For a switch, this command displays the following details: Ethernet IP Address,
Ethernet Subnetmask, Fibre Channel IP Address, and Fibre Channel Subnetmask.
For a CP, this command displays the following details: Ethernet IP Address,
Ethernet Subnetmask, Hostname and Gateway IP address.
In the StorageWorks Core switch the CPs communicate to each other through an
Ethernet in the backplane. When the option operand is specified as a 4, the
fixed Backplane IP addresses for CP0 and CP1 are also shown.
Use the option operand to specify the logical switch or CP you want to view. If the
option operand is not specified, then the command becomes interactive.
The default values for hostname, ipaddress, subnet address (for CP only), mask
(for switch only), and gateway address (for CPs only) are:
■ sw0 = hostname SW12000_1, ip 10.77.77.77, mask 255.0.0.0
■ sw1 = hostname SW12000_2, ip 10.77.77.76, mask 255.0.0.0
■ cp0 = hostname cp0, ip 10.77.77.75, subnet 255.0.0.0, gateway 0.0.0.0
■ cp1 = hostname cp1, ip 10.77.77.74, subnet 255.0.0.0, gateway 0.0.0.0
Operands
For V3.1.x, none.
For V4.1.x, this command has the following operand:
If no operand is specified the command becomes interactive.
option
Specify the option you would like to view. This operand is only
available for theStorageWorks Core switch. Valid option values
are:
■ 0 means display information for switch0.
■ 1 means display information for switch1.
■ 2 means display information for CP0.
■ 3 means display information for CP1.
■ 4 means display information all IP addresses in the system.