Specifications

Fabric OS Commands
348 Fabric OS Version 3.1.x/4.1.x Reference Guide
Example
To force the failover of the active CP to the standbyCP in the switch:
See Also
haDisable
haEnable
haShow
switch:admin> hafailover
Local CP (Slot 6, CP1): Active
Remote CP (Slot 5, CP0): Standby, Failed
HA enabled, Heartbeat Up, HA State Not in Sync
Warning: This command is being run on a control processor(CP) based system.
If the above status does not indicate HA State synchronized then this
operation will cause the active CP to reset. This will cause disruption to
devices attached to both switch 0 and switch 1 and will require that existing
telnet sessions be restarted. To just reboot a logical switch on this system,
use command switchreboot(1M) on the logical switch you intend to reboot.
Are you sure you want to reboot the active CP [y/n]? Y