Specifications

configure
157Fabric OS Version 3.1.x/4.1.x Reference Guide
System Services
The System Services fields are as follows:
Descriptions of the system service setting fields are as follows:
Always send RSCN? Following the completion of loop initialization, a
remote state change notification (RSCN) is issued
when FL_Ports detect the presence of new devices or
the absence of pre-existing devices. When set, a
RSCN is issued upon completion of loop initialization,
regardless of the presence or absence of new or
preexisting devices.
Do Not Allow AL_PA
0x00?
This option disallows AL_PA values from being 0.
Initialize All Looplets?
(V3.1.x only)
When this is set, all looplets including the ones not in
the same zone are always re-initialized. This is
required for certain RAID subsystems to work properly
during failover.
Table 5: Configure Command System Services Parameters
Field Default Range
rstatd Off On/Off
rusersd Off On/Off
telnetd (V4.1.x only)
On On/Off
rapid On On/Off
thad On On/Off
Disable RLS probing On On/Off
rstatd Dynamically enables or disables a server that returns
information about system operation information through
remote procedure calls (RPC). The protocol provides for
a wide-range of system statistics.
The retrieval of this information is supported by a
number of operating systems which support RPC. Most
UNIX-based systems (HP-UX, Irix, Linux, Solaris, etc.)
use the rup and rsysinfo commands to retrieve the
information. See your local system documentation for
the appropriate usage of the these or equivalent
commands.