Specifications

Fabric OS Commands
156 Fabric OS Version 3.1.x/4.1.x Reference Guide
RSCN Transmission Mode
The RSCN Transmission Mode field is as follows:
NS Operation Parameters
The NS Pre-zoning Mode field is as follows:
Arbitrated Loop Parameters
The Arbitrated Loop Setting fields are as follows:
Descriptions of the Arbitrated Loop Parameter fields are as follows:
End-device RSCN
Transmission Mode
Specify 0 for RSCN with single PID, 1 for RSCN with
multiple PIDs, or 2 fabric RSCN. The default value is 0.
Pre-zoned Responses
Mode
Specify 0 for Standard Mode, or 1 for Pre-zoning On.
The default value is 0.
Table 4: Configure Command Arbitrated Loop Settings
Field Default Range
Alternate BB Credit? (V4.1.x only) 0 0 or 1
Send FAN frames? 10 or 1
Enable CLOSE on OPEN received? 00 or 1
Always send RSCN? 10 or 1
Do Not Allow AL_PA 0x00? 00 or 1
Initialize All Looplets? (V3.1.x only) 0 0 or 1
Send FAN frames? Specifies that fabric address notification (FAN) frames
be sent to public loop devices to notify them of their
node ID and address. When set to 1, frames are sent;
when set to 0, frames are not sent.
Enable CLOSE on OPEN
received?
If this is set, a CLS is returned immediately to an OPN
if no buffers are available. This is required for
TachLite.