Specifications

Fabric OS Commands
136 Fabric OS Version 3.1.x/4.1.x Reference Guide
■ If a good checksum test, check that:
— CMI error bit is not set.
— CMI error interrupt status bit is not set.
■ if a bad checksum test, check that:
— CMI error bit is set.
— CMI error interrupt status bit is set.
5. Check that all other ASICs (~Y) do not have its:
■ Capture flag set.
■ CMI error bit set.
■ CMI error interrupt status bit set.
Operands
This command has the following operands:
passcnt
(V3.1.x only)
Specify the number of times to perform this test. The
default value is 1. This operand is optional.
--slot number
(V4.1.x only)
Specify the slot number to test. The default is set to 0 and
designed to operate on fixed port count products.
-passcnt count
(V4.1.x only)
Specify the number of test passes to run. By default the test
will be run one time.
-txports list
(V4.1.x only)
Specify a list of ports to transmit data. By default all the
ports in the specified slot (--slot number) will be
used. See itemlist help pages for further details. This
operand is optional.
-rxports list
(V4.1.x only)
Specify a list of ports to receive data. By default all the
ports in the specified slot (--slot number) will be
used. See itemlist help pages for further details.This
operand is optional.
-skip mask
(V4.1.x only)
Specify the particular test by using the following bit weight
data:
1 CMI data test (ignore checksum)
2 CMI checksum test
3 Enable all tests
This operand is optional.