Technical data

14 ServerIron ADX Advanced Server Load Balancing Guide
53-1002435-03
Configuring SIP SLB
1
NOTE
You can specify SIP port number 5060 or the keyword sip.
3. Specify a redirect server and a health check method.
ServerIronADX(config-rs-redirect-server-1)# port sip sip-redirect-server
health-check-method register
Syntax: port sip [sip-redirect-server] [options | health-check-method register]
[health-check-no-dsr]
• sip-redirect-server— Identifies the server as a SIP redirect server.
• health-check-method— Specifies the SIP health check method.
• options— Enables health check through OPTION messages.
• register— Enables health check through REGISTER messages (default method).
• health-check-no-dsr— Specifies for health check to be sent to a real server rather than a
virtual server.
Configuring a SIP virtual server
Complete the following steps to configure SIP SLB virtual redirect-proxy servers and virtual proxy
domains, and bind real servers to virtual servers.
1. Configure a virtual proxy domain name and IP address for Domain 1 and enter the virtual
server configuration mode.
ServerIronADX(config)# server virtual-name-or-ip proxy-domain-1 1.1.6.9
Syntax: [no] server virtual-name-or-ip <name> <ip address>
2. Specify the SIP port and SIP switch.
ServerIronADX(config-vs-proxy-domain-1)# port sip sip-switch
Syntax: [no] port sip sip-switch
This command must be used to enable the SIP switch for the virtual port.
NOTE
You can specify the logical SIP port number 5060 or the keyword sip.
3. Configure a domain and specify a SIP domain name and dummy user.
ServerIronADX(config-vs-proxy-domain-1)# port sip sip-user-name sipuser
domain-name domain-1
Syntax: [no] port sip [sip-user-name <user-name> [domain-name <domain-name>]]
NOTE
The domain name is optional. If you do not specify a domain name, the server IP address is
used.
4. Bind the real SIP registrar servers.
ServerIronADX(config-vs-proxy-domain-1)# bind sip registrar-1 sip registrar-2
sip
Syntax: bind sip <registrar-name> bind sip <registrar-name> sip