Technical data

Brocade ServerIron ADX Advanced Server Load Balancing Guide 41

53-1003441-01

Configuring transparent cache switching

• A cache group is defined in terms of input ports to the ServerIron ADX. To give a client access

to a group of cache servers, the input port connecting the client to the ServerIron ADX must be

in the cache group that contains the cache servers. If you plan to have only one cache group,

you do not need to add the input ports to the cache group because all ports are members of

cache group 1 by default.

• If you do not want a specific port to support TCS (for example, you want to redirect HTTP traffic

for that port directly to the Internet instead), then you need to remove that port from default

cache group 1.

• You must apply an IP policy to redirect Internet traffic to the cache servers. You can apply a

global or local policy. A global policy takes effect on all ports as soon as you configure the

policy. A local policy does not take effect until it is assigned to an interface. If you assign a local

policy, assign it to the output port connected to the Internet. The policy sends all HTTP traffic

addressed as output traffic to the port to the CPU instead for processing and forwarding.

• Although TCS can be concurrently be configured for cache servers with either IPv4 or IPv6

addresses, IPv4 traffic can only be directed to an IPv4 cache server and IPv6 traffic can only

be directed to an IPv6 cache server.

Defining a cache server

Once you have enabled TCS on the ServerIron ADX, assign a name and IP address to each cache

server. Once you have assigned the name and IP address, you can reference the server in CLI

commands by either the server’s name or its IP address.

To assign the names and IP addresses to the cache servers shown in Figure 9 on page 34, enter

commands such as the following:

For IPv4

ServerIron(config)#server cache-name server1 10.95.5.11

ServerIron(config-rs-server1)#server cache-name server2 10.95.5.129

ServerIron(config-rs-server2)#end

ServerIron#write memory

For IPv6

ServerIron(config)#server cache-name server3 2001:db8::30:1

ServerIron(config-rs-server3)#server cache-name server4 2001:db8::30:2

ServerIron(config-rs-server4)#end

ServerIron#write memory

Syntax: [no] server cache-name text { ipv4-addr | ipv6-addr }

The text variable specifies a name for the server. It can be any alphanumeric string of up to 42

characters.

The ipv4-addr variable specifies the IPv4 address of the web cache server.

The ipv6-addr variable specifies the IPv6 address of the web cache server.