Technical data

38 Brocade ServerIron ADX Advanced Server Load Balancing Guide
53-1003441-01
Sample deployment topologies
2
In Flow 1b, the ServerIron ADX changes the destination address in Flow 1a to that of the cache
server. CAM programming is the same as for basic TCS, as detailed in Table 1.
NOTE
FTP is not supported for TCS with destination NAT.
TCS with source NAT
To make sure that the reverse traffic from the cache server hits the ServerIron ADX, source NAT may be
used as shown in the following diagram:
In Flow 1b, the ServerIron ADX changes the source address to a configured IP address. The
ServerIron ADX applies source NAT to the requests going from the ServerIron ADX to the cache
server. Table 2 illustrates the CAM programming for this example.