Technical data

38 ServerIron ADX Graphical User Interface Guide
53-1002412-01
Configuring static routes
6
Enabling or disabling an interface
You can enable or disable an interface from the Summary page.
To enable or disable a virtual server, perform the following steps within the Configure tab.
1. Click Network on the menu bar.
2. From the sidebar, select Interfaces.
The list of all the configured interfaces is displayed in the main page as shown in Figure 23.
FIGURE 23 Enabling or disabling an interface
3. Select an interface from the table and perform one of the following actions:
• Click Enable at the bottom of the Summary page to enable the interface.
• Click Disable to disable the interface.
For more information on enabling or disabling an interface, refer to the ServerIron ADX Switch and
Router Guide.
Configuring static routes
The device uses static routes, when it does not have a route or cannot determine a route to a
destination. You can configure multiple static routes for load balancing and path redundancy.
To add a static route on the device, perform the following steps within the Configure tab.
1. Click Network on the menu bar.
2. From the sidebar, select Static Routes.