Installation guide

Brocade NetIron CES 2000 and NetIron CER 2000 Hardware Installation Guide 87
53-1001834-01
Diagnostic error codes and remedies for TFTP transfers
6
Reloading at a specific time
To schedule a system reload for a specific time, use one of the following methods.
To schedule a system reload from the primary flash module for 6:00:00 AM, January 19, 2006,
enter the following command at the Privileged EXEC level of the CLI.
NetIron# reload at 06:00:00 01-19-06
Syntax: reload at <hh:mm:ss> <mm-dd-yy> [primary | secondary]
<hh:mm:ss> is the hours, minutes, and seconds.
<mm-dd-yy> is the month, day, and year.
primary | secondary specifies whether the reload is to occur from the primary code flash module or
the secondary code flash module. The default is primary.
Reloading after a specific amount of time
To schedule a system reload to occur after a specific amount of time has passed on the system
clock, use one of the following methods.
To schedule a system reload from the secondary flash one day and 12 hours later, enter the
following command at the Privileged EXEC level of the CLI.
NetIron# reload after 01:12:00 secondary
Syntax: reload after <dd:hh:mm> [primary | secondary]
<dd:hh:mm> is the number of days, hours, and minutes.
primary | secondary specifies whether the reload is to occur from the primary code flash image or
the secondary code flash image.
Diagnostic error codes and remedies for TFTP transfers
If an error occurs with a TFTP transfer to or from a NetIron CES and NetIron CER 2000 Series
device, one of the error codes shown in Table 17 is displayed.