Installation guide

70 Brocade NetIron CES 2000 and NetIron CER 2000 Hardware Installation Guide

53-1001834-01

Fiber optic module replacement

3. Slide the fan tray out

4. Slide the new fan tray in and tighten the screws to secure it to the chassis.

5. Plug the chassis back in and power up..

Fiber optic module replacement

You can remove an SFP or XFP from a port and replace it with a new one while the NetIron CES and

NetIron CER 2000 Series device is powered on and running.

This section provides information about the following tasks:

• Removing a fiber optic module

• Installing a new fiber optic module

• Cabling a fiber optic module

Removing a fiber optic module

You can remove a fiber SFP (also called a mini-GBIC) or an XFP from a port while the NetIron CES

and NetIron CER 2000 Series device is powered on and running.

Before removing a fiber optic module, have the following on hand:

• An ESD wrist strap with a plug for connection to the ESD connector on the device.

CAUTION

For safety reasons, the ESD wrist strap should contain a series 1 Meg ohm resistor.