Installation guide

58 Brocade NetIron CES 2000 and NetIron CER 2000 Hardware Installation Guide
53-1001834-01
Power supply replacement
5
Removing the AC power supply
CAUTION
Do not use an electric screwdriver when installing or uninstalling power supplies.
Required tools
You will need the following tool to perform this procedure:
• #2 Phillips-head screwdriver
The following procedures are required when removing an AC power supplies from NetIron CES and
NetIron CER 2000 Series devices.
1. Unplug the power supply from the power source.
2. Disconnect the power cord from the power supply.
3. Unscrew the two power supply locking screws located at the top left and bottom right hand
corner of the power supply.
FIGURE 32 Power supply screw location
4. Pull the power supply outward once the screws have been unscrewed. This will disconnect the
power supply from the backplane.
1 Power supply locking screws
1