Installation guide

Brocade NetIron CES 2000 and NetIron CER 2000 Hardware Installation Guide 37

53-1001834-01

Operation verification

After you have installed any redundant power supplies, verify that the device is working properly by

plugging it into a power source and verifying that it passes its self test.

If your device has more than one power supply installed, repeat this procedure for each power

supply.

Verifying proper operation

1. Connect the power cord supplied with the device to the power connector on the power supply

on the rear of the device.

2. Insert the other end into a properly grounded electrical outlet.

3. Verify that the LED for each power supply is a solid green.

4. Verify proper operation by observing the LEDs.

All the port LEDs should flash momentarily, usually in sequence, while the device performs

diagnostics. After the diagnostics are complete, the LEDs will be dark except for the ones that

are attached by cables to other devices. If the links on these cables are good and the

connected device is powered on, the link LEDs will light.