Installation guide

Brocade NetIron CES 2000 and NetIron CER 2000 Hardware Installation Guide 11
53-1001834-01
Hardware features
1
• 10/100/1000 ports with RJ-45 copper connectors
• 100/1000 Hybrid Fiber (HF) ports
• 100/1000 ports with mini-GBIC slots for SFP MSA-compliant fiber transceivers
• NetIron CES 2000 and NetIron CES 2000 devices optionally support two 10-Gigabit Ethernet
uplink ports for 10-Gigabit Small Form Factor Pluggable (XFP) MSA-compliant optical
transceivers
Serial Management Interface (console port)
The Serial Management Interface enables you to configure and manage the device using a
third-party terminal emulation application on a directly connected PC. A straight-through EIA/TIA
DB-9 serial cable (F) ships with the device. The serial management interface (the port labeled
Console) is located in the front panel.
LEDs for NetIron CES and CER ports
The ports on NetIron CES 2000 and NetIron CER 2000 devices provide status information using
the LEDs listed in Table 2 and Table 3.
TABLE 2 LEDs for NetIron CES and NetIron CER 10/100/1000 Mbps ports
LED Position State Meaning
10/100/1000 Port LEDs
Lnk/Act Bottom Left
(Beneath the port -
indicates the
status of the
top(odd) port).
On Link is up.
Off Link is down.
Blinking Port is transmitting or receiving traffic
Lnk/Act Bottom Right
(beneath the port
indicates the
status of the lower
(even) ports).
On Link is up.
Off Link is down.
Blinking Port is transmitting or receiving traffic
TABLE 3 LEDs for the NetIron CES 2000 and NetIron CER 2000 Series 10-Gbps Ethernet ports
LED Port State Meaning
10-Gbps Port LEDs
Top Left hand port On The port is connected.
Off No fiber port connection exists.
Blinking Traffic is being transmitted and received on the
fiber port
Bottom Right hand port On The port is connected.
Off No fiber port connection exists.
Blinking Traffic is being transmitted and received on the
fiber port