Installation guide

88 Brocade NetIron CES 2000 and NetIron CER 2000 Hardware Installation Guide
53-1001834-01
PREMIUM package upgrade
6
TABLE 17 .Error codes, messages, and remedies
PREMIUM package upgrade
This section describes how to upgrade your NetIron CES and NetIron CER 2000 Series device to a
different PREMIUM software package.
If you have any questions about performing this upgrade, please refer to “Getting technical help or
reporting errors” on page xii for contact telephone numbers. You also can send email to
[e-mail].
Error code Message Explanation and action
1 Flash read preparation failed. A flash error occurred during the download.
Retry the download. If it fails again, contact customer
support
2Flash read failed.
3 Flash write preparation failed.
4 Flash write failed.
5 TFTP session timeout. TFTP failed because of a time out.
Check IP connectivity and make sure the TFTP server is
running.
6 TFTP out of buffer space. The file is larger than the amount of space on the device
or TFTP server.
If you are copying an image file to flash, first copy the
other image to your TFTP server, then delete it from flash.
(Use the erase flash... CLI command at the Privileged
EXEC level to erase the image in the flash.)
If you are copying a configuration file to flash, edit the file
to remove unneeded information, then try again.
7 TFTP busy, only one TFTP session can be
active.
Another TFTP transfer is active on another CLI session or
SNMP.
Wait, then retry the transfer.
8 File type check failed. You accidentally attempted to copy the incorrect image
code into the system.Retry the transfer using the correct
image.
16 TFTP remote - general error. The TFTP configuration has an error. The specific error
message describes the error.
Correct the error, then retry the transfer.
17 TFTP remote - no such file.
18 TFTP remote - access violation.
19 TFTP remote - disk full.
20 TFTP remote - illegal operation.
21 TFTP remote - unknown transfer ID.
22 TFTP remote - file already exists.
23 TFTP remote - no such user.