Installation guide
Table Of Contents
- Contents
- Preface
- About This Document
- Product Overview
- Introduction
- Product overview
- Software features
- Upgrade applications
- Hardware features
- Brocade NetIron CES Series 2024C-4X
- Brocade NetIron CES Series 2024F-4X
- Brocade NetIron CES Series 2024C
- Brocade NetIron CES Series 2024F
- Brocade NetIron CES Series 2048C
- Brocade NetIron CES Series 2048CX
- Brocade NetIron CES Series 2048F
- Brocade NetIron CES Series 2048FX
- Brocade NetIron CER Series 2024C
- Brocade NetIron CER Series 2024F
- Brocade NetIron CER Series 2048C
- Brocade NetIron CER Series 2048CX
- Brocade NetIron CER Series 2048F
- Brocade NetIron CER Series 2048FX
- Control features
- Network interfaces
- Power supplies
- Cooling system and fans
- Connecting to a Network Device
- Installation
- Device Management Applications Familiarization
- Hardware Specifications
- Hardware Maintenance
- Hardware maintenance schedule
- Power supply replacement
- 10-Gigabit Ethernet module installation or replacement
- Replacing the fan tray
- Copper or Fiber optic module replacement
- Fiber optic connector cleaning
- Regulatory Statements
- Caution and Danger Notices
- Index
NOTE
Brocade NetIron CES/CER-4X-RT supports the XNI-CE-2000-FAN pre-installed or as a spare. All other
models support the NI-CE-2000-FAN.
The fans in the devices include six four-speed fans that operate at low speed, medium speed, medium-
high speed, and high speed based on the ambient temperature and configured or default temperature
thresholds. All fans operate simultaneously at the same speed. If a single fan fails within the assembly,
the fan tray should be replaced. The fan tray is hot swappable and the mean time to recover (MTTR) is
one minute.
The system uses a default or configured temperature threshold associated with it to determine at which
speed the fan should operate.
Product Overview
Brocade NetIron CES 2000 Series and NetIron CER 2000 Series Hardware Installation Guide 37
53-1003263-02