Hardware manual

Version 1.1, 03/31/2015
GSS CCT Evaluation Technical Report Page 44 of 56 © 2015 Gossamer Security Solutions, Inc.
Document: AAR-BrocadeNetIron5.8 All rights reserved.
TSS Assurance Activities: None Defined
Guidance Assurance Activities: None Defined
Testing Assurance Activities: The evaluator shall perform the following test:
Test 1: The evaluator follows the operational guidance to configure several different values for the inactivity time
period referenced in the component. For each period configured, the evaluator establishes a remote interactive
session with the TOE. The evaluator then observes that the session is terminated after the configured time period.
The evaluator set the SSH time period to 1 minute and observed a SSH timeout. The evaluator then set the SSH
timeout to 2 minutes and observed a SSH timeout. Note that when the session terminated, the screen was left as-
is and a new login prompt was presented. This was repeated for the web interface (on the MLX platform) with the
same results.
2.7.2 USER-INITIATED TERMINATION (FTA_SSL.4)
2.7.2.1 FTA_SSL.4.1
TSS Assurance Activities: None Defined
Guidance Assurance Activities: None Defined
Testing Assurance Activities: The evaluator shall perform the following test:
Test 1: The evaluator initiates an interactive local session with the TOE. The evaluator then follows the operational
guidance to exit or log off the session and observes that the session has been terminated.
The evaluator established a local session and manually ‘exit’ed per the command identified in the guidance. In
each case the session was terminated and a logout audit record was logged.
2.7.3 TSF-INITIATED SESSION LOCKING (FTA_SSL_EXT.1)