Technical data

400 Brocade Mobility 7131 Access Point Product Reference Guide
53-1002517-01
8
Wlan Kerb Auth Failed : disable
WWAN event : disable
Health Check event : disable
For information on configuring SNMP traps using the applet (GUI), see Enabling SNMP Traps on
page 4-93.
br7131>admin(system.snmp.traps)>set
Description:
Sets SNMP trap parameters.
Syntax:
set mu-assoc enable/disab
le
Enables/disables the MU associated trap.
mu-unassoc
enable/disab
le
Enables/disables the MU unassociated trap.
mu-deny-assoc
enable/disab
le
Enables/disables the MU association denied trap.
mu-deny-auth
enable/disab
le
Enables/disables the MU authentication denied trap.
snmp-auth
enable/disab
le
Enables/disables the authentication failure trap.
snmp-acl
enable/disab
le
Enables/disables the SNMP ACL violation trap.
port
enable/disab
le
Enables/disables the physical port status trap.
dos-attack
enable/disab
le
Enables/disables the denial of service trap.
interval <rate> Sets denial of service trap interval.
cold
enable/disab
le
Enables/disables the system cold start trap.
cfg
enable/disab
le
Enables/disables a configuration changes trap.
rogue-ap enable/disab
le
Enables/disables a trap when a rogue-ap is detected.
ap-radar
enable/disab
le
Enables/disables the AP Radar Detection trap.
wpa-counter
enable/disab
le
Enables/disables the WPA counter measure trap.
hotspot-mu-status
enable/disab
le
Enables/disables the hotspot mu status trap.
vlan enable/disab
le
Enables/disables VLAN traps.
lan-monitor
enable/disab
le
Enables/disables LAN monitor traps.
rate <rate> <scope> <value> Sets the particular <rate> to monitor to <value> given the
indicated <scope>. See table below for information on the
possible values for <rate>, <scope>, and <value>.