Technical data

Brocade Mobility 7131 Access Point Product Reference Guide 281

53-1002517-01

Chapter

CLI Reference

In this chapter

•Connecting to the CLI . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 281

•Admin and Common Commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 282

•Network Commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 286

•System Commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 378

•Statistics Commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 433

The Mobility 7131 Access Point Command Line Interface (CLI) is accessed through the serial port

or a Telnet session. The Mobility 7131 Access Point CLI follows the same conventions as the

Web-based user interface. The CLI does, however, provide an “escape sequence” to provide

diagnostics for problem identification and resolution.

NOTE

The CLI commands described in this guide pertain equally to both the Mobility 7131 Access Point

and Mobility 7131N model access points.

The CLI treats the following as invalid characters:

< > | " & \ ? ,

In order to avoid problems when using the CLI, these characters should be avoided.

Connecting to the CLI

Accessing the CLI through the Serial Port

To connect to the Mobility 7131 Access Point CLI through the serial port:

8. Connect one end of a null modem serial cable to the Mobility 7131 Access Point’s serial

connector.

9. Attach the other end of the null modem serial cable to the serial port of a PC running

HyperTerminal or a similar emulation program.

10. Set the HyperTerminal program to use 19200 baud, 8 data bits, 1 stop bit, no parity, no flow

control, and auto-detect for terminal emulation.

11. Press <ESC> or <Enter> to enter into the CLI.

12. Enter the default username of admin and the default password of admin123. If this is your first

time logging into the access point, you are unable to access any of the access point’s

commands until the country code is set. A new password will also need to be created.