Installation guide

Configuring basic device settings
3
Brocade Mobility 7131N-FGR Access Point Installation Guide 39
53-1001948-01
To define the attributes of the VPN tunnel:
1. Select Network Configuration -> WAN -> VPN from the access point menu tree.
2. Select the Add button from within the VPN Tunnels field to define the attributes
of a new tunnel to provide secure access to the access point’s external NTP,
syslog or Radius resources.
3. Refer to the VPN Tunnel Config field and define the following attributes for the
VPN tunnel:
Tunnel Name
Enter a name to define the VPN tunnel. The tunnel name is used
to uniquely identify each tunnel.
Interface name
Use the drop-down menu to specify the LAN1, LAN2 or WAN
connection used for routing VPN traffic. Remember, only one LAN
connection can be active on the access point Ethernet port at a
time.
AP7131N_InstallationGuide.book Page 39 Tuesday, August 24, 2010 5:09 AM