Installation guide

Brocade FastIron LS and FastIron LS-STK Hardware Installation Guide 33
53-1002187-01
Upgrading hardware
3
DRAFT: BROCADE CONFIDENTIAL
FIGURE 30 EEPROM socket U2 and memory DIMM locations on FLS 648 devices
8. To replace the memory DIMM, see Figure 31 on page 34. Open the DIMM holder by pushing
the tabs apart. Lift the old DIMM up and pull it out of the holder.
9. Slide the new DIMM into the holder at an angle (see Figure 31) and push the connector end
into the holder until it snaps into place.
10. Push straight down on the DIMM to lock it into place in the holder.
1 FLS648 Front Panel 2 FLS Rear Panel
3 Memory DIMM 4 Socket U2
5Pin 1 6EEPROM
+
1
4
6
2
3
5