Installation guide

Brocade FastIron LS and FastIron LS-STK Hardware Installation Guide 31

53-1002187-01

Upgrading hardware

DRAFT: BROCADE CONFIDENTIAL

6. Remove the EEPROM from the package and align the lead pins over the EEPROM socket

(socket U12 for FLS624 devices, socket U2 for FLS648 devices). Refer to Figure 29 on page 32

for the EEPROM socket and Memory DIMM locations on FLS devices.

The semicircular indentation on the EEPROM is located on the same end as pin 1.

FIGURE 28 Pin 1 on EEPROM

7. Align the semicircular indentation on the EEPROM with the semicircular cut-out on the

EEPROM socket and gently push the EEPROM into the socket.

CAUTION

Make sure you insert the EEPROM so that lead pin 1 goes into the correct hole as shown in the

appropriate illustrations. If you accidentally insert the EEPROM backwards, the device will not

work and may be damaged when you apply power.

CAUTION

Do not push too hard. If the EEPROM does not readily go into the socket, stop pushing and verify

that the lead pins are straightened and properly aligned over the holes. Straighten any crooked

pins, then try again.

1 Pin 1 2 Semicircular indentation