Installation guide

22 Brocade FastIron LS and FastIron LS-STK Hardware Installation Guide
53-1002187-01
Installing a redundant power supply
2
DRAFT: BROCADE CONFIDENTIAL
Desktop or shelf mounting
1. Attach the four adhesive feet to the bottom of the first RPS device.
FIGURE 21 Attaching the adhesive feet
2. Set the device on a flat surface near an AC power source, making sure there are at least two
inches of space on all sides for proper air flow.
Connecting devices to the redundant power supply
The RPS2-EIF unit can be used with all FastIron LS and FastIron LS-STK devices.
Follow the steps below to connect devices to the redundant power supply.
1. Connect one end of the AC cable to the AC receptacle on the supported device, and the other
end to a grounded power outlet.
FIGURE 22 Power receptacle
2. Connect one end of a DC cable to the redundant power receptacle on the supported device
and the other end to an available receptacle on the RPS device.
3. Repeat steps 1 and 2 for connecting up to four supported devices to the RPS device.
4. Connect one end of the AC cable to the AC receptacle on the RPS device, and the other end to
a grounded power outlet.
100-240V, 50-60Hz 10A
RPS 1