Installation guide

Brocade FastIron LS and FastIron LS-STK Hardware Installation Guide 15
53-1002187-01
Preparing the installation site
2
DRAFT: BROCADE CONFIDENTIAL
FIGURE 14 Attaching the brackets
3. Attach the device in the rack as illustrated in Figure 15.
FIGURE 15 Installing the device in a rack
4. If you are installing a single device, proceed to “Powering on the system” on page 26.
5. If you are installing multiple devices, mount them in the rack, one below the other, in any order.
6. If you are also installing a redundant power supply, mount it in the rack below the other
devices.
Connecting devices in a stack
Figure 16 shows how the stack cables are connected between devices in a stack. The connection is
based on 10 Gbps Ethernet, using CX4 cables. FLS-STK devices support linear and ring stack
topologies, and can also operate as standalone devices. For detailed information about configuring
and managing an IronStack, see the FastIron Configuration Guide.
Fastlron
LS
624
FLS
624
624
Fastlron
LS
624
FLS