Network Router User Manual

Brocade ICX 6650 Layer 3 Routing Configuration Guide 471
53-1002603-01
enabling multicast routing on GRE tunnels, 106
GRE packet
, 95
multicast routing over GRE tunnels
, 97
point-to-point GRE tunnels
, 95
IPv6
advertising address summaries
, 160
clearing RIPng routes
, 163
clearing tunnel statistics
, 405
configuring a manual tunnel
, 404
displaying ECMP load-sharing information
, 409
displaying interface-level settings
, 406
displaying tunnel information
, 405
ECMP load sharing
, 408
static route parameters
, 402
IPv6 over IPv4 tunnels
, 403
ipv6 rip summary-address
, 160
L
Layer 2
enabling or disabling
, 139
Layer 2 switch
basic IP parameters and defaults
, 17
configuring IP parameters
, 88
displaying IP information
, 128
interface IP parameters
, 19
IP global parameters
, 17
Layer 3
modifying and displaying parameter limits
, 134
Layer 3 switch
basic IP parameters and defaults
, 11
configuring a default network route
, 54
configuring to drop IP packets
, 49
IP global parameters
, 11
IP interface parameters
, 15
load balancing, configuring using multiple static routes
, 49
log messages for DHCP
, 87
M
management IP address
configuring and specifying the default gateway
, 88
Maximum Transmision Unit (MTU)
changing
, 28
changing on an individual port
, 30
path discovery (RFC 1191) support
, 30
Maximum Transmission Unit (MTU)
globally changing
, 29
MTU
changing the value for a tunnel interface
, 104
configuring path discovery
, 105
path discovery
, 96
multicast protocols
displaying information
, 110
N
network routes
configuring default
, 54
O
Open Shortest Path First (OSPF)
differences between version 2 and version 3
, 228
overview
, 168
point-to-point links
, 169
OSPF
assigning a totally stubby area
, 180
assigning an area range
, 183
assigning areas
, 179
assigning interfaces to an area
, 184
assigning virtual links
, 189
auth-change-wait-time
, 185
authentication-key
, 185
block flooding of outbound LSAs
, 187
changing administrative distance
, 207
changing the reference bandwidth
, 194
changing the reference bandwidth for the cost
, 192
changing the timer for authentication changes
, 186
clearing information
, 212
clearing information for areas
, 213
clearing redistributed routes from the routing table
,
213
clearing topology information
, 213
CLI commands
, 214
configirng group Link State Advertisement (LSA)
pacing
, 208
configuration
, 177
configuring a non-broadcast interface
, 188
configuring a point-to-point link
, 211
configuring default route origination
, 205
configuring external route summarization
, 204
configuring graceful restart
, 211
cost
, 185
dead-interval
, 185
defining redistribution filters
, 194
designated router election in multi-access networks
,
170