Network Router User Manual

Brocade ICX 6650 Layer 3 Routing Configuration Guide 361
53-1002603-01
Displaying BGP4 information
Syntax: [no] snmp-server enable traps bgp
Use the no form of the command to disable BGP traps.
Displaying BGP4 information
You can display the following configuration information and statistics for the BGP4 protocol on the
router:
• Summary BGP4 configuration information for the router
• Active BGP4 configuration information (the BGP4 information in the running-config)
• CPU utilization statistics
• Neighbor information
• Peer-group information
• Information about the paths from which BGP4 selects routes
• Summary BGP4 route information
• The router BGP4 route table
• Route flap dampening statistics
• Active route maps (the route map configuration information in the running-config)
• BGP4 graceful restart neighbor information
Displaying summary BGP4 information
You can display the local AS number, the maximum number of routes and neighbors supported,
and some BGP4 statistics.
To view summary BGP4 information for the router, enter the show ip bgp summary command at any
CLI prompt.