Network Router User Manual

274 Brocade ICX 6650 Layer 3 Routing Configuration Guide
53-1002603-01
Displaying OSPF V3 Information
IPsec examples
This section contains examples of IPsec configuration and the output from the IPsec-specific show
commands. In addition, IPsec-related information appears in general show command output for
interfaces and areas.
The show commands that are specific to IPsec are:
• show ipsec sa
• show ipsec policy
• show ipsec statistics
The other show commands with IPsec-related information are:
• show ipv6 ospf area
• show ipv6 ospf interface
Showing IPsec security association information
The show ipsec sa command displays the IPsec security association databases, as follows.
Brocade#show ipsec sa
IPSEC Security Association Database(Entries:8)
SPDID(if) Dir Encap SPI Destination AuthAlg EncryptAlg
ALL in ESP 512 2001:db8:1::1 sha1 Null
eth1/1/1 out ESP 302 :: sha1 Null
eth1/1/1 in ESP 302 2001:db8:: sha1 Null
eth1/1/1 out ESP 512 2001:db8:1::2 sha1 Null
ALL in ESP 512 2001:db8:1::1 sha1 Null
eth1/1/2 out ESP 302 :: sha1 Null
eth1/1/2 in ESP 302 2001:db8:: sha1 Null
eth1/1/2 out ESP 512 2001:db8:1::2 sha1 Null
Syntax: show ipsec sa
State The state between the Brocade device and the virtual neighbor. The state can
be one of the following:
• Down
• Attempt
• Init
• 2-Way
• ExStart
• Exchange
• Loading
• Full
Interface The IPv6 address of the virtual neighbor.
TABLE 56 OSPF V3 virtual neighbor information (Continued)
Field Description