Network Router User Manual

Brocade ICX 6650 Layer 3 Routing Configuration Guide 131
53-1002603-01
Displaying IP configuration information and statistics
total The total number of ICMP messages sent or received by the device.
errors This information is used by Brocade customer support.
unreachable The number of Destination Unreachable messages sent or received by the device.
time exceed The number of Time Exceeded messages sent or received by the device.
parameter The number of Parameter Problem messages sent or received by the device.
source quench The number of Source Quench messages sent or received by the device.
redirect The number of Redirect messages sent or received by the device.
echo The number of Echo messages sent or received by the device.
echo reply The number of Echo Reply messages sent or received by the device.
timestamp The number of Timestamp messages sent or received by the device.
timestamp reply The number of Timestamp Reply messages sent or received by the device.
addr mask The number of Address Mask Request messages sent or received by the device.
addr mask reply The number of Address Mask Replies messages sent or received by the device.
irdp advertisement The number of ICMP Router Discovery Protocol (IRDP) Advertisement messages sent or
received by the device.
irdp solicitation The number of IRDP Solicitation messages sent or received by the device.
UDP statistics
received The number of UDP packets received by the device.
sent The number of UDP packets sent by the device.
no port The number of UDP packets dropped because the packet did not contain a valid UDP port
number.
input errors This information is used by Brocade customer support.
TCP statistics
The TCP statistics are derived from RFC 793, “Transmission Control Protocol”.
current active tcbs The number of TCP Control Blocks (TCBs) that are currently active.
tcbs allocated The number of TCBs that have been allocated.
tcbs freed The number of TCBs that have been freed.
tcbs protected This information is used by Brocade customer support.
active opens The number of TCP connections opened by this device by sending a TCP SYN to another
device.
passive opens The number of TCP connections opened by this device in response to connection requests
(TCP SYNs) received from other devices.
failed attempts This information is used by Brocade customer support.
active resets The number of TCP connections this device reset by sending a TCP RESET message to the
device at the other end of the connection.
passive resets The number of TCP connections this device reset because the device at the other end of the
connection sent a TCP RESET message.
input errors This information is used by Brocade customer support.
TABLE 25 CLI display of IP traffic statistics – Layer 2 Switch (Continued)
Field Description