Installation guide

1 Bail Latch
FIGURE 23 Unlocking the bail latch
NOTE
The bail latch may be attached to either the top or the bottom of the SFP+ or QSFP+ transceiver.
4. Grasp the bail latch and pull the copper or fiber-optic module out of the port, as shown in the
following figure.
FIGURE 24 Removing the fiber-optic module
5. Store the copper or fiber-optic module in a safe, static-free place or in an anti-static bag.
6. Install a new copper or fiber-optic module in the port.
Cabling a fiber-optic module
For instructions on cabling a fiber-optic module, refer to Cabling a fiber-optic transceiver on page 47.
Cleaning the fiber-optic connectors
For instructions on cleaning a fiber-optic module, refer to Cleaning the fiber-optic connectors on page
47.
Cabling a fiber-optic module
Brocade ICX 6650 Hardware Installation Guide 59
53-1003398-01