Installation guide

Deleting an IP address
Enter a command similar to the following to delete an IP address.
device(config-if-1/1/1)# no ip address 1.1.2.1
This command deletes IP address 1.1.2.1. You do not need to enter the subnet mask.
To delete all IP addresses from an interface, enter the following command.
device(config-if-1/1/1)# no ip address *
Syntax: no ip address ip-addr | *
Connecting network devices
Brocade devices support connections to other vendors’ routers, switches, and hubs, as well other
Brocade devices.
Connectors
For port pinouts, refer to Pinouts and signaling on page 72.
Connecting a network device to a fiber port
For direct attachment from the device to a Gigabit NIC, switch, or router, using a fiber-optic
transceiver, you need fiber cabling with an LC connector.
For information about transceivers supported on the Brocade ICX 6650, refer to the following Brocade
website:
http://www.myBrocade.com/downloads/documents/data_sheets/product_data_sheets/Optics_DS.pdf
To connect the device to another network device using a fiber port, you must perform the following
tasks:
• Install a fiber-optic transceiver (SFP or SFP+).
• Cable the fiber-optic transceiver.
Installing a transceiver
You can install a new transceiver in an SFP+ slot while the device is powered on and running.
While installing a transceiver, wear an ESD wrist strap with a plug for connection to a metal surface.
DANGER
For safety reasons, the ESD wrist strap should contain a series 1 megaohm resistor.
DANGER
All fiber-optic interfaces use Class 1 lasers.
Use the following steps to install a transceiver:
Deleting an IP address
46 Brocade ICX 6650 Hardware Installation Guide
53-1003398-01