Installation guide

Brocade ICX 6430-C Compact Switch Hardware Installation Guide 39

53-1002817-02

Pinouts and signalling

Cable specifications

For information about supported transceivers and cable lengths and types, refer to the following

Brocade website at:

http://www.brocade.com/downloads/documents/data_sheets/product_data_sheets/Optics_

DS.pdf

NOTE

Cable installation and network configuration affects overall transmission capability. For

network-specific recommendations, consult your local Brocade reseller or system engineer.

Power cords

NOTE

Brocade recommends that you use the power cord that is shipped with the device.

For an ICX 6430-C device to operate at 100V, the power cord should be C13 type connector with

10A rating or better (NEMA-5-15 plug).

For an ICX 6430-C device to operate at 240V, the power cord should be C13 type connector with

10A rating or better.

All devices ship with United States compatible power cords at the time of order. United Kingdom-

and European-compatible power cords are also available.

3 UART0_TX Console Port

4GND

5GND

6 UART0_RX Console Port

7NC

8NC

TABLE 13 Console serial RJ45 management port pinouts (Continued)

Pin number Definition Notes