Installation guide

Brocade ICX 6430-C Compact Switch Hardware Installation Guide 25
53-1002817-02
Installing the device
2
Use the magnet mount kit to mount the device on a metal wall or a metal surface, including
underneath a metal desk. The magnet mount kit is available for order seperately from the device
and consists of a single magnet sheet.
Before mounting the device to a metal surface using the magnet sheet, ensure that the following
requirements are met:
• Adequate ventilation is provided for the system. Allow 3 cm. of clearance above the device and
8 cm. of clearance on each side.
• The magnet sheet is attached to the bottom panel of the device. See “Attaching the magnet
sheet to the device”.
• Ensure that the device is not installed above a height of 110 mm. from the floor.
Note the following important installation considerations before installing the device on a metal
surface using the magnet mount:
• The strength of the magnet will vary depending on the the surface it is used on.
• The magnet’s force might weaken over time. Please check the strength of the magnet
regularly, for about one year. Please move the device up and down and confirm strength.
When adequate ventilation is provided and the magnet is attached to the device, you can securely
mount the device in the following locations:
• A metal wall or metal surface. See “Mounting the device on a metal surface or metal wall”.
• Underneath a metal desktop. See “Mounting the device under a metal desk”.
Attaching the magnet sheet to the device
Before mounting the device to a metal surface, place the logo side of the magnet sheet (displaying
the Brocade logo) squarely against the bottom panel of the device to attach the device to the
magnet sheet. See Figure 15.
CAUTION
The magnet sheet can only be placed against the bottom panel of the device. Do not attempt to
attach the magnet sheet to any other panels on the device.