Installation guide

Brocade ICX 6430-C Compact Switch Hardware Installation Guide 23
53-1002817-02
Installing the device
2
Wall mount installation using wall mount brackets
NOTE
You need a #2 Phillips screwdriver, a hammer, and a drill for wall mount installation.
NOTE
When mounting the device on a wall, Brocade recommends that you mount the device with the port
side down.
To mount the ICX 6430-C device to a wall, use the rack-mount kit that can be ordered seperately
from the device (Brocade Part Number: ICX6400-RMK). The rack-mount kit is not included with the
device. Brocade recommends that you wall mount the device with the port side down.
Complete the following steps to mount the device to a wall.
1. Using a Phillips screwdriver, attach the wall mount brackets to the sides of the device using
four sink-head screws, as illustrated in Figure 13.
FIGURE 13 Attaching the wall mount brackets for an ICX 6430-C device
2. Drill two holes on the wall where you want to mount the device, as illustrated in Figure 14.
3. Hammer two wall mount anchors into the holes on the wall, as illustrated in Figure 14.
4. Use the two wall mount screws to fasten the device to the wall mount anchors, as illustrated in
Figure 14.