Installation guide

Brocade ICX 6430-C Compact Switch Hardware Installation Guide 19
53-1002817-02
Installing the device
2
Complete the following steps to mount the device directly to a wall.
1. Use tape to place the Wall Mount Holes Location template against the wall, in the same
position that you plan to place the device against the wall. The Wall Mount Holes Location
template serves as a guide to drilling the screws and mount anchors into the correct location
on the wall in order to place the device in the desired location.
2. Using the the Wall Mount Holes Location template as a guide, drill two holes on the wall where
you want to mount the device. See Figure 10.
3. Hammer the wall mount anchors into the two holes. See Figure 10.
4. Use the #2 Phillips screwdriver to secure the two wall mount screws into the wall mount
anchors. Leave a gap of 4.0 to 4.5 mm between the screw head and the wall. See Figure 10.