Installation guide

8 Brocade ICX 6430-C Compact Switch Hardware Installation Guide
53-1002817-02
Port, system, and power status LEDs
1
If a problem persists after taking these actions, contact Brocade Technical Support.
SFP
(F1 - F2, Slot
3)
On or
flashing
(Green)
The SFP port is operating.
Flashing green indicates
the port is transmitting
and receiving user
packets.
Off A link is not established with the
remote port. You can do the following:
Verify that the connection to the
other network device has been
properly made. Also, make
certain that the other network
device is powered on and
operating correctly.
Verify that the transmit port on
the device is connected to the
receive port on the other
network device, and that the
receive port on the device is
connected to the transmit port
on the other network device. If
you are not certain, remove the
two cable connectors from the
port connector and reinsert
them in the port connector,
reversing their order.
Dust may have accumulated in
the cable connector or port
connector.
Verify that the port has not been
disabled through a configuration
change.
If the other actions do not
resolve the problem, try using a
different port or a different
cable.
Uplink ports
(C1-C2, Slot
2)
On or
flashing
(Green)
The ports are operating.
Flashing green indicates
the port is transmitting
and recieving user
packets.
Off A link is not established with the
remote port. You can do the following:
Verify that the connection to the
other network device has been
properly made. Also, make
certain that the other network
device is powered on and
operating correctly.
Verify that the port has not been
disabled through a configuration
change. You can use the CLI. If
you have configured an IP
address on the device, you also
can use the Web management
interface or Brocade Network
Advisor.
If the other actions do not
resolve the problem, try using a
different port or a different
cable.
TABLE 4 Network connection-related LED states (Continued)
LED Desired
state
Meaning Abnormal state Meaning or action