Installation guide

Brocade ICX 6430-C Compact Switch Hardware Installation Guide 3
53-1002817-02
Network and management interfaces
1
Reset button
The reset button allows you to restart the system without switching the power supplies off and on
or using the CLI or Web Management Interface. When reset button is pressed, the system resets
and the software is reloaded. The button is directly below the power LED on the very left of the
device’s front panel.
Network interfaces for a ICX 6430-C device
An ICX 6430-C12 device contains the following interfaces:
• 12 1GbE ports with RJ45 copper connectors (Slot 1, Ports 1- 12)
- Ports 1- 4 are dedicated PoE/PoE+ ports.
Standard 802.3at PoE+ ports support up to 30W per port.
Standard 802.3af PoE ports support up to 15.4W per port.
Total PoE power capacity is 68W.
Some possible PoE/PoE+ configuration combinations include:
• 2 standard PoE ports supporting full capacity (15.4W x 2 = 30.8W)
1 standard PoE+port supporting full capacity (30W)
1 PoE or PoE+ port supporting partial capacity, no greater than 7W (7W)
Total PoE/PoE+ power: 67.8W
• 2 standard PoE+ ports supporting full capacity (30W x 2 = 60W)
1 PoE or PoE+ port supporting partial capacity, no greater than 7W (7W)
Total PoE/PoE+ power: 67W
• 4 standard PoE ports supporting full capacity (15.4W x 4 = 62W)
Total PoE power: 62W
• 4 100/1GbE uplink ports:
- 2 100/1GbE RJ45 uplink ports (Slot 2, ports C1-C2)
- 2 100/1GbE SFP uplink ports (Slot 3, ports F1-F2)
Slot designations
Table 1 lists the slot designations for an ICX 6430-C device. Refer to Figure 3 for the location of
slots 1- 3 on the front panel of an ICX 6430-C device.
TABLE 1 Slot designations for a ICX 6430-C device
Device Slot 1 (1GbE RJ45 ports) Slot 2 (100/1GbE RJ45 ports) Slot 3 (100/1GbE SFP ports)
ICX 6430-C12 1GbE ports 1-12 100/1GbE ports C1- C2 100/1GbE SFP ports F1-F2