Technical data

286 Fabric OS Encryption Administrator’s Guide (DPM)

53-1002720-02

Brocade Encryption Switch removal and replacement

27. Invoke the following command on the new Brocade Encryption Switch:

Admin:switch> cfgsave

28. Reconnect the FC Cables to the new Brocade Encryption Switch.

29. Invoke the cfgsave command on any switch in that fabric. The fabric configuration from the

existing fabric is merged into the new Brocade Encryption Switch.

30. Verify that defzone is set as no access.

31. If HA cluster membership for the old Brocade Encryption Switch was in place. Do the following

for moving container movement to the new Brocade Encryption Switch.

a. Replace the old EE with the new EE using the following command on the group leader.

Admin:switch> cryptocfg -–replace <WWN of Old BES> <WWN of new BES>

b. Issue commit.

Admin:switch> cryptocfg --commit

c. Replace the HAC membership from the old EE to the new EE using the following command

on the group leader.

Admin:switch> cryptocfg –-replace –haclustermember <HA cluster name> <WWN

of Old BES> <WWN of New BES>

d. Issue commit.

Admin:switch> cryptocfg –-commit

e. If “manual” failback was set on the HA cluster, you must manually fail back the LUNs

owned by the newly replaced Brocade Encryption Switch.

32. If HA cluster membership for the old Brocade Encryption Switch was not in place. Do the

following for moving container to the New BES.

a. Replace the old EE with the new EE using following command on the group leader.

Admin:switch> cryptocfg -–replace <WWN of Old BES> <WWN of new BES>

b. Issue commit.

Admin:switch> cryptocfg --commit

33. Check the EG state using the following command to ensure that the entire EG is in a converged

and In Sync state.

Admin:switch> cryptocfg –-show –groupcfg