Technical data

Converged Enhanced Ethernet Command Reference 37
53-1002508-01
debug lacp
2
debug lacp
Enables debugging for the Link Aggregation Control Protocol (LACP).
Synopsis debug lacp {all | cli | ha | event | nsm | pdu {rx all | rx interface tengigabitethernet slot/port} | tx
all | tx interface tengigabitethernet slot/port}| sync | timer | trace level number}
no debug lacp {all | cli | event | nsm | pdu {rx all | rx interface tengigabitethernet slot/port} | tx all
| tx interface tengigabitethernet slot/port}| sync | timer | trace level number}
Operands all Turns on all debugging.
cli Turns on command line interface (CLI) debugging.
ha Turns on High Availablity debugging.
event Turns on event debugging.
nsm Turns on Network Services Module (NSM) debugging.
pdu Turns on protocol data unit (PDU) debugging.
rx all Turns on debugging for received LACP packets on all interfaces.
rx interface Turns on debugging for received LACP packets on the specified
interface.
interface tengigabitethernet
Specifies the 10 Gbps Ethernet interface.
slot Specifies the slot number.
port Specifies the port number.
tx all Turns on debugging for transmitted LACP packets on all interfaces.
tx interface Turns on debugging for transmitted LACP packets on the specified interface.
interface tengigabitethernet
Specifies the 10 Gbps Ethernet interface.
slot Specifies the slot number.
port Specifies the port number.
sync Turns on debugging for LACP sync transitions.
timer Turns on debugging for LACP timers.
trace level number Specifies the trace level number. The range of valid values is from 1 through
7.
Defaults By default, debugging is not turned on. The default trace level is 6.
Command
Modes
Privileged EXEC mode
EXEC mode
Description Use this command to enable debugging for Link Aggregation Control Protocol (LACP). Use the no
debug command to disable debugging.