Technical data

Converged Enhanced Ethernet Command Reference 245
53-1002508-01
switchport mode
2
switchport mode
Sets the mode of the Layer 2 interface.
Synopsis switchport mode {access | trunk | converged}
Operands access Sets the Layer 2 interface as access.
trunk Sets the Layer 2 interface as trunk.
converged Sets the Layer 2 interface as converged.
Defaults None
Command
Modes
Interface configuration mode
Description Use this command to set the mode of the Layer 2 interface.
Usage
Guidelines
Converged mode is not available in interface port-channel configuration mode.
Examples To set the mode of the interface to access:
switch(conf-if-te-0/19)#switchport mode access
To set the mode of the interface to trunk:
switch(conf-if-te-0/19)#switchport mode trunk
To set the mode of the interface to converged:
switch(conf-if-te-0/19)#switchport mode converged
See Also show vlan, show interface, switchport mode, switchport trunk