Technical data

Converged Enhanced Ethernet Command Reference 189
53-1002508-01
show qos flowcontrol interface
2
show qos flowcontrol interface
Displays all of the configured flow control information for an interface.
Synopsis show qos flowcontrol interface {tengigabitethernet slot/port | all}
Operands tengigabitethernet
Reports QoS flow control statistics for a single 10 Gbps Ethernet interface.
slot Specifies the 10 Gbps Ethernet line card slot number within the chassis.
port Specifies the 10 Gbps Ethernet port number within the port.
all Reports QoS flow control statistics for all interfaces within the system.
Defaults None
Command
Modes
Privileged EXEC mode
EXEC mode
Description Use this command to display all of the configured flow control information for a specific interface.
Usage
Guidelines
Use this command to display the runtime state retrieved from the dataplane reflecting the
operation of 802.3x pause or Priority Flow Control (PFC) on an interface. The administrative state
for pause generation and reception or processing is presented for the interface (802.3x mode) or
for each CoS (PFC mode). TX_Pause frame generation statistics are always presented for the
interface. The RX_Pause BitTimes is presented for the interface (802.3x mode) or for each CoS
(PFC mode). When PFC is deployed under the CEE Provisioning model, then the command reports
whether the Data Center Bridging eXchange protocol (DCBX) has overridden the user configuration.
Examples To display all of the configured flow control information for a 10 Gbps Ethernet interface:
switch#show qos flowcontrol interface tengigabitethernet 0/1
Interface TenGigabitEthernet 0/1
Mode PFC
DCBX enabled for PFC negotiation
TX 0 frames
TX TX RX RX Output Paused
CoS Admin Oper Admin Oper 512 BitTimes
---------------------------------------
0 Off Off Off Off 0
1 Off Off Off Off 0
2 On Off On Off 0
3 Off Off Off Off 0
4 Off Off Off Off 0
5 Off Off Off Off 0
6 Off Off Off Off 0
7 Off Off Off Off 0
See Also show qos interface, show cee maps