Technical data

Converged Enhanced Ethernet Command Reference 161
53-1002508-01
show interface
2
show interface
Displays the configuration and status of an interface.
Synopsis show interface {tengigabitethernet slot/port | port-channel number| switchport}
Operands tengigabitethernet
Specifies a valid 10 Gbps Ethernet interface.
slot Specifies a valid slot number.
port Specifies a valid port number.
port-channel number
Specifies the interface is a port-channel. The range of valid values is from 1
through 63.
switchport Specifies the Layer 2 interface.
Defaults None
Command
Modes
Privileged EXEC mode
EXEC mode
Description Use this command to show the running system status and configuration for a specified interface.
Usage
Guidelines
None
Examples To display information for a 10 Gbps Ethernet interface:
switch#show interface tengigabitethernet 0/1
TenGigabitEthernet 0/1 is up, line protocol is down (link protocol down)
Hardware is Ethernet, address is 0005.1e53.ebab
Current address is 0005.1e53.ebab
Pluggable media not present
Interface index (ifindex) is 402718721
MTU 2500 bytes
Beacon is turned off
LineSpeed: 10000 Mbit, Duplex: Full
Flowcontrol rx: on, tx: on
Last clearing of show interface counters: 11:55:28
Queueing strategy: fifo
Receive Statistics:
0 packets, 0 bytes
Unicasts: 0, Multicasts: 0, Broadcasts: 0
64-byte pkts: 0, Over 64-byte pkts: 0, Over 127-byte pkts: 0
Over 255-byte pkts: 0, Over 511-byte pkts: 0, Over 1023-byte pkts: 0
Over 1518-byte pkts(Jumbo): 0
Runts: 0, Jabbers: 0, CRC: 0, Overruns: 0
Errors: 0, Discards: 0
Transmit Statistics:
0 packets, 0 bytes
Unicasts: 0, Multicasts: 0, Broadcasts: 0
Underruns: 0
Errors: 0, Discards: 0
Rate info (interval 299 seconds):