Technical data

Converged Enhanced Ethernet Command Reference 93
53-1002508-01
lacp timeout
2
lacp timeout
Sets the timeout value used by LACP to exchange packets on a dynamic trunk port.
Synopsis lacp timeout {long | short}
no lacp timeout
Operands timeout Specifies the number of seconds before invalidating a received Link
Aggregation Control Protocol (LACP) data unit.
long Specifies a long timeout value.
short Specifies a short timeout value.
Defaults By default, the short timeout value is 3 seconds for Brocade trunks. For standard trunks, the long
timeout value is 90 seconds.
Command
Modes
Interface configuration mode
Description Use this command to set the short timeout value for Brocade trunks or to set the long timeout
value for standard trunks.
Usage
Guidelines
If the LACP_timeout bit (encoded in Actor_State and Partner_State fields) is set to 1, the short
timeout takes effect; if set to 0 (zero), the long timeout takes effect.
Use the no lacp timeout command to return to the default value.
Examples To set the LACP short timeout value:
switch(conf-if-te-0/1)#lacp timeout short
To set the LACP long timeout value:
switch(conf-if-te-0/1)#lacp timeout long
See Also None