User guide

Brocade 6910 Ethernet Access Switch Configuration Guide 869
53-1002581-01
Access Control Lists
41
FIGURE 205 Configuring an Extended IPv6 ACL
Configuring a MAC ACL
Use the Security > ACL (Configure ACL - Add Rule - MAC) page to configure a MAC ACL based on
hardware addresses, packet format, and Ethernet type.
CLI References
• “permit, deny (MAC ACL)” on page 252
• “show ip access-list” on page 245
• “Time Range” on page 102
Parameters
These parameters are displayed:
• Type – Selects the type of ACLs to show in the Name list.
• Name – Shows the names of ACLs matching the selected type.
• Action – An ACL can contain any combination of permit or deny rules.
• Source/Destination Address Type – Use “Any” to include all possible addresses, “Host” to
indicate a specific MAC address, or “MAC” to specify an address range with the Address and
Bit Mask fields. (Options: Any, Host, MAC; Default: Any)
• Source/Destination MAC Address – Source or destination MAC address.
• Source/Destination Bit Mask – Hexadecimal mask for source or destination MAC address.
• Packet Format – This attribute includes the following packet types:
• Any – Any Ethernet packet type.
• Untagged-eth2 – Untagged Ethernet II packets.
• Untagged-802.3 – Untagged Ethernet 802.3 packets.